EUREKA GRANITE

APPLICATION ON TABLES, BATHROOM OR KITCHEN WORKTOP, BAR COUNTERS AND CLADDING:

Surface preparation: the surface must be dry and clean. Wash the surface to remove dirt and any residues of old waxes and treatments (we recommend using our ULTRA STRIPPER); rinse thoroughly and dry. Apply a small amount of product (10–15 g) to the surface to be treated, moisten with a few drops of water; place the Eureka Pad on the gel and polish using an orbital sander with adjustable speed set to a low rpm, between 800 and 1500 rpm (1000 rpm is optimal). Work the surface until the gel has completely dried and the desired gloss is achieved. Clean any residue with water and Ultra Stripper alkaline detergent. If necessary, the procedure described above may be repeated.

We recommend using the Eureka Pad as it offers the perfect balance between the right softness and uniform density, a combination that enhances Eureka Granito, allowing it to reach working temperature quickly.

FLOOR APPLICATION:

Surface preparation: the surface must be dry and clean. Wash the floor thoroughly using a single-disc machine and a suitable pad, removing dirt and any residues of old waxes and treatments (we recommend using our ULTRA STRIPPER); rinse very thoroughly and dry with a wet vacuum.  Apply a small amount (approximately 30 grams) of “Eureka” directly onto the floor, under the natural fibre pad, moisten slightly, then buff with a single-disc machine (at 150–400 rpm and a minimum weight of 30 kg) over approximately 1–2 m² of floor. Spray or pour water if the gel dries too quickly during application. After applying the product, work the surface until the gel dries, achieving the desired shine. Finally, wash and rinse with water and an alkaline substance (soda, bicarbonate of soda or our ULTRA STRIPPER cleaner) to remove any product residue and neutralise any residual acidity.

One litre of the product is sufficient to cover approximately 30–35 m².