Strong 2000

STRONG 2000

Silane/Siloxane based, protective water repellent and consolidant. Indicated for the protection of all vertical natural stone surfaces and masonry materials against water penetration, moisture, mould, acid rains, atmospheric conditions and smog buildups, providing long lasting protection. Due to its consolidant characteristics, product can be applied to soft and delicate stones to avoid potential chalking, crumbing and surface flaking as a surface hardener. Completely transparent, product does not change or alter the natural appearance of the material. Reduces the formation of mold, mildew, salts and efflorescence. PFAS free – formulated without added Pfas

Method of use :
ALWAYS TEST PRODUCT FIRST following below indications, before proceeding with complete product application. Ensure that surfaces to be treated are completely dry and clean, free of dirt, dust, grime and surface incrustations. Cover and protect all surrounding areas before proceeding with application.
Manual: Product is ready for use. Apply an abundant coat of product uniformly using a soft bristled brush to material. Allow surface to absorb product for 5 minutes before applying a second coat of product (where needed). Remove all eventual excess product, pooling or residues within 15 minutes using a clean cotton cloth, dry roller or microfiber, until all excess product is absorbed.
Airless: (spray) Using a low pressured hand-held spray or airless, apply product maintaining a distance from surface of 20-25 cm. Allow product to be absorbed into surface before applying a second coat as indicated above. On vertical surfaces, apply two coats of product wet on wet. Start at the bottom and work the way up. Dry up and remove eventual product drips. Place tarp or plastic protective sheeting below the treated area to catch eventual drips. Allow product to penetrate completely in all cracks, holes and open areas.
Notes: During application, product should be applied to materials with temperature between 10° and 30°C. Before application to floors with underfloor heating, turn off all heating and allow floor to cool completely before product application. Maintain product in its original container/packaging. Always test product first.
Coverage:
Marbles, granites and compact materials: 15/25m²*
Calcareous stones, sandstones, Marble/cement: 5/15m²*
(*) depending on the number of coats, texture and porosity of the surface.
Packaging:
Available in the following sizes: 1 lt., 5 lt., 25 lt., 200 lt.