SUPER CRYSTAL POWDER MARBLE

1. Spread SUPER CRYSTAL on the floor manually in a circle, approximately a couple of square metres (approx. 20 square feet). Position the single disc machine equipped with a natural fiber disc on the powder on the floor. 2. Using a sprayer, or with solution tank water control, wet the floor with water and then turn on the floor machine and work water and SUPER CRYSTAL into slurry. Add SUPER CRYSTAL or water as necessary to maintain a watery slurry. Rotation of the machine may splatter the slurry, so take care to protect adjoining areas of carpet, wood and walls. 3. Work areas of no more than 1-2 square meters (15-20 square feet) at a time. DO NOT ALLOW THE SLURRY TO DRY ON THE FLOOR AT ANY TIME. 4. After running the floor machine over the 15-20 square feet area 3 or 4 times, use 16” or 18” window squeegee and pull across the area to check result. When a high polish in this area has been achieved, move the slurry with the squeegee to the next area to be polished. 5. Rinse the floor with clean water and make sure all SUPER CRYSTAL slurry has been removed from the surface and grout joints. 6. Repeat polishing process using the same slurry by adding water or SUPER CRYSTAL as needed, until the entire area has reached the desired polish. 7. Wash the floor thoroughly with clean water and alkaline detergent such as DECER-DOS or ULTRA STRIPPER and leave it to dry.

With 1 kg (35 oz.) of product is possible to polish 40/50 m2 (430/540 sq.ft.) depending on degree of wear of floor.